Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2016TITAN XD SL, 5.0L ENG VIN B, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM (INTRODUCTION) (5.6L))SYSTEM DESCRIPTIONDIAGNOSIS SYSTEM (ECM)CONSULT FUNCTIONDTC WORK SUPPORT MODE
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WD
DTC Work Support Mode
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WDSECTION DTC Work Support Mode
WARNING: This page is about a different variant/trim than selected.
| Test Mode | Test Item | Corresponding DTC No. | Reference |
|---|---|---|---|
| HO2S2 | HO2S2 (B1) P1146 | P0138 | DTC DESCRIPTION |
| HO2S2 (B1) P1147 | P0137 | DTC DESCRIPTION | |
| HO2S2 (B1) P0139 | P0139 | DTC DESCRIPTION | |
| HO2S2 (B2) P1166 | P0158 | DTC DESCRIPTION | |
| HO2S2 (B2) P1167 | P0157 | DTC DESCRIPTION | |
| HO2S2 (B2) P0159 | P0159 | DTC DESCRIPTION | |
| A/F SEN1 | A/F SEN1 (B1) P1278/P1279 | - | |
| A/F SEN1 (B1) P1276 | P0130 | DTC DESCRIPTION | |
| A/F SEN1 (B2) P1288/P1289 | - | ||
| A/F SEN1 (B2) P1286 | P0150 | DTC DESCRIPTION | |
| EVAPORATIVE SYSTEM | EVP V/S LEAK P0456/P1456* | P0456 | DTC DESCRIPTION |
| PURG VOL CN/V P1444 | P0443 | DTC DESCRIPTION | |
| PURG FLOW P0441 | P0441 | DTC DESCRIPTION |
*: DTC P1456 does not apply but appears in DTC Work Support Mode screens.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.