Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2016TITAN XD SL, 5.0L ENG VIN B, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM (INTRODUCTION) (5.6L))SYSTEM DESCRIPTIONCOMPONENT PARTSCOMPONENT LOCATIONBODY COMPARTMENT
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WD
Body Compartment
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WDSECTION Body Compartment
WARNING: This page is about a different variant/trim than selected.
| Left Rear Wheel Area | Steering Wheel | Pedal Periphery | |||
| Inside Fuel Tank | Behind Fuel Tank | ||||
| : Vehicle Front |
| No. | Component Parts | Function |
|---|---|---|
| Fuel Pump Control Module (FPCM) | FUEL PUMP CONTROL MODULE | |
| ASCD Steering Switch | ASCD STEERING SWITCH | |
| Stop Lamp Switch | BRAKE PEDAL POSITION SWITCH & STOP LAMP SWITCH | |
| Brake Pedal Position Switch | ||
| Accelerator Pedal Position Sensor | ACCELERATOR PEDAL POSITION SENSOR | |
| Fuel Pump | FUEL PUMP CONTROL MODULE | |
| Fuel Tank Temperature Sensor | ||
| Fuel Level Sensor Unit | ||
| EVAP Canister Vent Control Valve | EVAP CANISTER VENT CONTROL VALVE | |
| EVAP Control System Pressure Sensor | EVAP CONTROL SYSTEM PRESSURE SENSOR | |
| EVAP Canister | EXPLODED VIEW WITH TORQUE SPECIFICATIONS |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.