Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2016TITAN XD SL, 5.0L ENG VIN B, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (INTRODUCTION) (5.0L)SYSTEM DESCRIPTIONCOMPONENT PARTSCOMPONENT LOCATIONBODY COMPARTMENT
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WD
Body Compartment
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WDSECTION Body Compartment
| Steering wheel | Behind front grille | Pedal periphery | |||
| Transmission | Behind fuel tank | Left rear side under carriage |
| No. | Component | Function |
|---|---|---|
| Combination meter | Mainly transmits the following signals to ECM via CAN communication.
Refer to COMBINATION METER for detailed installation location. |
|
| BCM | Mainly transmits the following signals to ECM via CAN communication.
Refer to REMOVAL AND INSTALLATION . |
|
| ECM | ECM | |
| TCM | Mainly transmits the following signal to ECM via electrical signal.
Mainly transmits the following signal to ECM via CAN communication:
Refer to TCM for detailed installation location. |
|
| ASCD Steering Switch | ASCD STEERING SWITCH | |
| Refrigerant Pressure Sensor | REFRIGERANT PRESSURE SENSOR | |
| Stop Lamp Switch | STOP LAMP SWITCH/ASCD CANCEL SWITCH | |
| Brake Pedal Position Switch | ||
| Accelerator Pedal Position Switch | ACCELERATOR PEDAL POSITION SENSOR | |
| Transmission Range Switch | TRANSMISSION RANGE SWITCH | |
| Fuel Pump | FUEL PUMP ACTUATOR | |
| Stage 1 Filter Assembly | REMOVAL AND INSTALLATION | |
| Water In Fuel Sensor | WATER IN FUEL SENSOR | |
| DEF (Diesel Exhaust Fluid) Control Module | DEF CONTROL MODULE | |
| DEF (Diesel Exhaust Fluid) Dosing Control Module | DEF SUPPLY PUMP ASSEMBLY | |
| DEF (Diesel Exhaust Fluid) Quality Sensor | DEF QUALITY SENSOR |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.