Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2016TITAN XD SL, 5.0L ENG VIN B, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWARNING SYSTEMSDRIVER ASSISTANCE SYSTEM (ADAS CONTROL UNIT)ECU DIAGNOSIS INFORMATIONADAS CONTROL UNITREFERENCE VALUEVALUES ON THE DIAGNOSIS TOOL
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WD
Values On The Diagnosis Tool
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WDSECTION Values On The Diagnosis Tool
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Monitor Item | Condition | Value/Status | |
|---|---|---|---|
| VHCL SPEED SE | While driving | Displays the vehicle speed calculated by ADAS control unit | |
| WARN SYS SW | Ignition switch ON | When warning system switch is pressed | On |
| When warning system switch is not pressed | Off | ||
| BSW/BSI WARN LMP | Ignition switch ON | BSW warning lamp ON | On |
| BSW warning lamp OFF | Off | ||
| BSW SYSTEM ON | Ignition switch ON | When the BSW system is ON (BSW indicator on the information display is ON) |
On |
| When the BSW system is OFF (BSW indicator on the information display is OFF) |
Off | ||
| BSW ON INDICATOR | Engine running | BSW ON indicator is ON. (Vehicle detected) | On |
| BSW ON indicator is OFF. (No vehicle detected) | Off | ||
| SIDE RADAR BLOCK COND | Engine running | Side radar or rear bumper is dirty. | On |
| Side radar or rear bumper is clean. | Off | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.