Diagnosis System (Av Control Unit): Description

2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WDSECTION Description

The AV control unit on board diagnosis performs the functions listed in the table below:

Mode Item Content
Version - Version data of the AV control unit is displayed.
User Configuration Touch Display Calibration - Calibration of the touch panel display can be performed.
Screenshot to USB - A screenshot of the display can be saved to USB memory.
Time Interval - Destination time interval can be selected.
Radio FM monitor - Monitors the dynamic values of the current tuner
AM monitor -
SXM monitor - Version data is displayed.
System State Running System Status
  • SD card slot access.
  • Power Supply
  • Speed Signal
  • Direction Signal
  • Illumination Signal
  • GPS Antenna
  • GPS tracking
  • Satellites visible
  • Satellites tracked
  • Microphone Current
  • Steer. wheel key
  • Radio Antenna
  • #No translation requi...
  • SXM Antenna
  • USB Device
  • iPod firmware ver.
  • BT Status
The current system status is displayed.
Speaker Test 4kHz - This activates a sequence of test tone outputs to the audio circuits one after the other for 1 second.
Speaker Test 100Hz
Display-Test - This provides a test sequence where test displays (plain colored display: e.g. white, black, red, blue, green) are shown one after the other.
The respective color is shown for an indicated period of time (parameter). After the display test, the design of the display previously available is stored. While the screen shows a plain colored display, a pixel malfunction may be detected.
Self Test
  • SD Card Access
  • BT Module Access
  • GPS Antenna
  • Radio Antenna
  • SXM Antenna
A system self test is executed and the results are stored into the error memory.

Perform CONSULT diagnosis if the AV control unit on board diagnosis does not start or the screen does not display anything.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.