Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2016TITAN XD SL, 5.0L ENG VIN B, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSSECURITY CONTROL SYSTEMSYSTEM DESCRIPTIONDIAGNOSIS SYSTEM (BCM)INTELLIGENT KEYCONSULT FUNCTION (BCM - INTELLIGENT KEY)ACTIVE TEST
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WD
Active Test
2016 Nissan-Datsun Titan XD SL, 5.0L Eng VIN B, 4WDSECTION Active Test
| Test Item | Description |
|---|---|
| INTELLIGENT KEY LINK (CAN) | This test is able to check Intelligent Key identification number [Off/ID No1/ID No2/ID No3/ID No4/ID No5]. |
| INT LAMP | This test is able to check interior room lamp operation [On/Off]. |
| FLASHER | This test is able to check hazard lamp operation [LH/RH/Off]. |
| HORN | This test is able to check horn operation [On]. |
| BATTERY SAVER | This test is able to check battery saver operation [On/Off]. |
| OUTSIDE BUZZER | This test is able to check Intelligent Key warning buzzer operation [On/Off]. |
| INSIDE BUZZER | This test is able to check combination meter warning chime operation [Take Out/Knob/Key/Off]. |
| INDICATOR | This test is able to check combination meter warning lamp operation [KEY ON/KEY IND/Off]. |
| IGN CONT2 | This test is able to check ignition relay-2 control operation [On/Off]. |
| ENGINE SW ILLUMI | This test is able to check push-button ignition switch START indicator operation [On/Off]. |
| PUSH SWITCH INDICATOR | This test is able to check push-button ignition switch indicator operation [On/Off]. |
| ACC CONT | This test is able to check accessory relay control operation [On/Off]. |
| IGN CONT1 | This test is able to check ignition relay-1 control operation [On/Off]. |
| ST CONT LOW | This test is able to check starter control relay operation [On/Off]. |
| IGNITION RELAY | This test is able to check ignition relay operation [On/Off]. |
| TRUNK/LUGGAGE LAMP TEST | This test is able to check cargo lamp illumination operation [On/Off]. |
| KEYFOB PW TEST | This test is able to check power window operation using the Intelligent Key [P/W up/down OFF/Send P/W down ON/Send P/W up ON]. |
| SHIFTLOCK SOLENOID TEST | This test is able to check shift lock solenoid operation [On/Off]. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.