SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODES (DTCS) P014C-P0643)DTC/CIRCUIT DIAGNOSISDTC P0453: EVAP CONTROL SYSTEM PRESSURE SENSORCOMPONENT INSPECTIONDIAGNOSTIC TEST
2015 Nissan-Datsun Rogue SV, AWD

Diagnostic Test

2015 Nissan-Datsun Rogue SV, AWDSECTION Diagnostic Test

  1. CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR

    1. Turn ignition switch OFF.
    2. Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister.

      Always replace O-ring with a new one. 

    3. Install a vacuum pump to EVAP control system pressure sensor.
    4. Turn ignition switch ON and check output voltage between ECM harness connector and ground under the following conditions.
      ECM Condition
      [Applied vacuum kPa (kg/cm2 , psi)]      		 Voltage
      Connector + -
      Terminal
      E16 114 124 Not applied 0.5 - 4.6 V
      -26.7 (-0.272, -3.87) 2.1 to 2.5 V lower than above value
      CAUTION:
      • Always calibrate the vacuum pump gauge when using it.
      • Do not apply below - 93.3 kPa (- 0.952 kg/cm2 , - 13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm2 , 14.69 psi).

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace EVAP control system pressure sensor. Refer to REMOVAL AND INSTALLATION .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.