Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Data Monitor
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
: Applicable
| Item (Unit) | Monitor item selection | Note | |
|---|---|---|---|
| INPUT SIGNALS | MAIN SIGNALS | ||
| FR LH SENSOR [km/h (MPH)] |
* | * | Wheel speed calculated by front LH wheel sensor is displayed. |
| FR RH SENSOR [km/h (MPH)] |
* | * | Wheel speed calculated by front RH wheel sensor is displayed. |
| RR LH SENSOR [km/h (MPH)] |
* | * | Wheel speed calculated by rear LH wheel sensor is displayed. |
| RR RH SENSOR [km/h (MPH)] |
* | * | Wheel speed calculated by rear RH wheel sensor is displayed. |
| DECEL G-SEN (m/s2 ) |
* | * | Decel G detected by decel G sensor is displayed. |
| FR RH IN SOL (On/Off) |
* | Operation status of front RH wheel ABS IN valve is displayed. | |
| FR RH OUT SOL (On/Off) |
* | Operation status of front RH wheel ABS OUT valve is displayed. | |
| FR LH IN SOL (On/Off) |
* | Operation status of front LH wheel ABS IN valve is displayed. | |
| FR LH OUT SOL (On/Off) |
* | Operation status of front LH wheel ABS OUT valve is displayed. | |
| RR RH IN SOL (On/Off) |
* | Operation status of rear RH wheel ABS IN valve is displayed. | |
| RR RH OUT SOL (On/Off) |
* | Operation status of rear RH wheel ABS OUT valve is displayed. | |
| RR LH IN SOL (On/Off) |
* | Operation status of rear LH wheel ABS IN valve is displayed. | |
| RR LH OUT SOL (On/Off) |
* | Operation status of rear LH wheel ABS OUT valve is displayed. | |
| EBD WARN LAMP (On/Off) |
Brake warning lamp ON/OFF status is displayed. (Note 1) | ||
| STOP LAMP SW (On/Off) |
* | * | Stop lamp switch signal input status is displayed. |
| MOTOR RELAY (On/Off) |
* | ABS motor and motor relay status is displayed. | |
| ACTUATOR RLY (On/Off) |
* | ABS actuator relay status is displayed. | |
| ABS WARN LAMP (On/Off) |
* | ABS warning lamp ON/OFF status is displayed. (Note 1) | |
| OFF LAMP (On/Off) |
* | VDC OFF indicator lamp ON/OFF status is displayed.(Note 1) | |
| SLIP/VDC LAMP (On/Off) |
* | VDC warning lamp ON/OFF status is displayed.(Note 1) | |
| BATTERY VOLT (V) |
* | * | Voltage supplied to ABS actuator and electric unit (control unit) is displayed. |
| GEAR | * | * | Current gear position judged from current gear position signal is displayed. |
| SLCT LVR POSI | * | * | Current gear position judged from current gear position signal is displayed. |
| YAW RATE SEN (d/s) |
* | * | Yaw rate detected by yaw rate sensor is displayed. |
| R POSI SIG (On/Off) |
R range signal input status judged from R range signal is displayed. | ||
| 4WD MODE MON(Note 2) (AUTO/LOCK/2WD) |
* | * | AWD control status is displayed. |
| N POSI SIG (On/Off) |
N range signal input status judged from N range signal is displayed. | ||
| P POSI SIG (On/Off) |
P range signal input status judged from P range signal is displayed. | ||
| ACCEL POS SIG (%) |
* | Displays the Accelerator pedal position | |
| SIDE G-SENSOR (m/s2 )) |
* | Side G detected by side G sensor is displayed. | |
| STR ANGLE SIG | * | Steering angle detected by steering angle sensor is displayed. | |
| PRESS SENSOR (bar) |
* | Brake fluid pressure detected by pressure sensor is displayed. | |
| EBD SIGNAL (On/Off) |
EBD operation status is displayed. | ||
| ABS SIGNAL (On/Off) |
ABS operation status is displayed. | ||
| TCS SIGNAL (On/Off) |
TCS operation status is displayed. | ||
| VDC SIGNAL (On/Off) |
VDC operation status is displayed. | ||
| EBD FAIL SIG (On/Off) |
EBD fail-safe signal status is displayed. | ||
| ABS FAIL SIG (On/Off) |
ABS fail-safe signal status is displayed. | ||
| TCS FAIL SIG (On/Off) |
TCS fail-safe signal status is displayed. | ||
| VDC FAIL SIG (On/Off) |
VDC fail-safe signal status is displayed. | ||
| CRANKING SIG (On/Off) |
Cranking status is displayed. | ||
| FLUID LEV SW (On/Off) |
* | Brake fluid level signal input status via CAN communication is displayed. | |
| PARK BRAKE SW (On/Off) |
* | Parking brake switch signal input status via CAN communication is displayed. | |
| USV[FL-RR] (On/Off) |
Primary side USV solenoid valve (On/Off) status is displayed. | ||
| USV[FR-RL] (On/Off) |
Secondary side USV solenoid valve (On/Off) status is displayed. | ||
| HSV[FL-RR] (On/Off) |
Primary side HSV solenoid valve (On/Off) status is displayed. | ||
| HSV[FR-RL] (On/Off) |
Secondary side USV solenoid valve (On/Off) status is displayed. | ||
| V/R OUTPUT (On/Off) |
Valve relay operation signal (On/Off) status is displayed. | ||
| M/R OUTPUT (On/Off) |
Motor relay operation signal (On/Off) status is displayed. | ||
| ENGINE RPM (tr/min) |
* | Engine speed status is displayed. | |
| DDS SW(Note 3) | Downhill Drive Support switch status is displayed. | ||
| DDS SIG(Note 3) | Downhill Drive Support operation status is displayed. | ||
| USS SIG (Note 4) (On/Off) |
hill start assist operation status is displayed. | ||
Note 1: Refer to SYSTEM DESCRIPTION for ON/OFF conditions of each warning lamp and indicator lamp.
Note 2: AWD models
Note 3: DDS (Downhill Drive Support)
Note 4: USS (Hill Start Assist)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.