Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEM (VDC/TCS/ABS)DTC/CIRCUIT DIAGNOSISVDC OFF SWITCHCOMPONENT INSPECTIONDIAGNOSTIC TEST
2015 Nissan-Datsun Rogue SV, AWD
Diagnostic Test
2015 Nissan-Datsun Rogue SV, AWDSECTION Diagnostic Test
- CHECK VDC OFF SWITCH
- Turn the ignition switch OFF.
- Disconnect VDC OFF switch harness connector.
- Check the continuity between terminals of VDC OFF switch connector.
VDC OFF switch Condition Continuity Terminal 6-8 When VDC OFF switch is pressed Yes When VDC OFF switch is not pressed No
Is the inspection result normal?
YES
Inspection End.
NO
Replace the VDC OFF switch. Refer to REMOVAL AND INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.