Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEM (VDC/TCS/ABS)DTC/CIRCUIT DIAGNOSISDTC C1109: POWER AND GROUND SYSTEMDTC LOGICDTC CONFIRMATION PROCEDURE
2015 Nissan-Datsun Rogue SV, AWD
DTC Confirmation Procedure
2015 Nissan-Datsun Rogue SV, AWDSECTION DTC Confirmation Procedure
- CHECK SELF DIAGNOSTIC RESULT
With CONSULT.
- Turn the ignition switch OFF to ON.
- Perform "Self Diagnostic Result".
Is DTC C1109 detected?
YES
Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .
NO
Inspection End.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.