Freeze Frame Data (FFD)

2015 Nissan-Datsun Rogue SV, AWDSECTION Freeze Frame Data (FFD)

When DTC is detected, a vehicle state shown below is recorded and displayed on CONSULT.

Item name Indication/Unit Display item
Odometer/Trip meter km Total mileage (Odometer value) of the moment a particular.
DTC LOCAL CODE - DTC code is displayed but not used.
CAN DIAG PERMIS CONDITION Off / On Displays CAN network diagnosis status.
BRAKE SWITCH 1 Off / On Displays brake switch operating status (Off: close / On: open).
BRAKE SWITCH 2 Off / On Displays brake switch operating status (Off: open / On: close).
ABS NORMAL / ABNOR Displays ABS function status.
TCS NORMAL / ABNOR Displays TCS function status.
VDC NORMAL / ABNOR Displays VDC function status.
VEHICLE SPEED km Displays the vehicle speed.
FR WHEEL SPEED RPM Displays the rotational speed of front RH tire.
FL WHEEL SPEED RPM Displays the rotational speed of front LH tire.
RR WHEEL SPEED RPM Displays the rotational speed of rear RH tire.
RL WHEEL SPEED RPM Displays the rotational speed of rear LH tire.
STEERING ANG SENSOR deg Displays the steering angle from the steering angle sensor.
SIDE G SENSOR G Displays the side G.
DECEL G SENSOR G Displays the decel G.
YAW RATE SENSOR deg/s Displays the yaw rate.
THRTL OPENING % Displays the electric throttle position.
SHIFT POSITION Off / P / R / N / D (A) / S / L / B / 1- 6 / M 1 -M 8 / A 1 - A 6 Displayed but not used.
PRESS SENSOR bar Displays the brake fluid pressure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.