Lumbar Support: Assembly

2015 Nissan-Datsun Rogue SV, AWDSECTION Assembly

Assembly is in the reverse order of disassembly.

CAUTION:
  • Do not reuse the side air bag module nuts.
  • Inspect seatback pad, seatback trim and seatback trim chutes. Replace if damaged.
  • Smooth out all wrinkles during assembly.
  • Always route side air bag module harness in original location. Replace any deformed or damaged clips with same type and color. Always install clips in the original location in the harness.
  • After work is completed, check that no system malfunction is detected causing the air bag warning lamp to illuminate.
  • If a malfunction is detected by the air bag warning lamp after repair or replacement of the malfunction parts, perform the SRS final check. Refer to TROUBLE DIAGNOSIS WITH CONSULT .
  • When installing the side air bag module, make sure there are no wrinkles and the chute is not folded, twisted or pinched.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.