Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY CONTROL SYSTEM (WITH INTELLIGENT KEY)SYSTEM DESCRIPTIONDIAGNOSIS SYSTEM (BCM)COMMON ITEMCONSULT FUNCTION (BCM - COMMON ITEM)SYSTEM APPLICATION

2015 Nissan-Datsun Rogue SV, AWD

System Application

2015 Nissan-Datsun Rogue SV, AWDSECTION System Application

BCM can perform the following functions.

System	Sub System	Direct Diagnostic Mode
System	Sub System	ECU Identification	Self Diagnostic Result	Data Monitor	Active Test	Work support	Configuration	CAN Diag Support Mntr
Door lock	DOOR LOCK		*	*	*	*
Rear window defogger	REAR DEFOGGER			*	*	*
Warning chime	BUZZER			*	*
Interior room lamp timer	INT LAMP			*	*	*
Exterior lamp	HEADLAMP			*	*	*
Wiper and washer	WIPER			*	*	*
Turn signal and hazard warning lamps	FLASHER			*	*
Intelligent Key system	INTELLIGENT KEY		*	*	*	*
Combination switch	COMB SW			*
BCM	BCM	*	*			*	*	*
Immobilizer	IMMU		*	*	*
Interior room lamp battery saver	BATTERY SAVER			*	*
Back door open	TRUNK			*
Vehicle security system	THEFT ALM			*	*	*
RAP system	RETAINED PWR			*
Signal buffer system	SIGNAL BUFFER			*
Air conditioner	AIR CONDITIONER				*

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.