SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY CONTROL SYSTEM (WITH INTELLIGENT KEY)DTC/CIRCUIT DIAGNOSISDTC B27D2: START CUT RELAY ONDTC LOGICDTC DETECTION LOGIC
2015 Nissan-Datsun Rogue SV, AWD

DTC Detection Logic

2015 Nissan-Datsun Rogue SV, AWDSECTION DTC Detection Logic
NOTE:
  • If DTC B27D2 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC LOGIC .
  • If DTC B27D2 is displayed with DTC B2605, first perform the trouble diagnosis for DTC B2605. Refer to DTC LOGIC .
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
B27D2 STARTER CUT RELAY ON When comparing the starter cut relay signal (CAN) from IPDM E/R, BCM detects that starter cut relay is stuck in the ON position for 1 second or more.
  • Harness or connectors

    (The CAN communication line is open or shorted.)

  • Harness or connector

    (Starter cut relay circuit is open or shorted.)

  • IPDM E/R
  • BCM
  • Starter cut relay
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.