Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY CONTROL SYSTEM (WITH INTELLIGENT KEY)DTC/CIRCUIT DIAGNOSISDTC B27D1: START CUT RELAY OFFCOMPONENT INSPECTION
2015 Nissan-Datsun Rogue SV, AWD
Component Inspection
2015 Nissan-Datsun Rogue SV, AWDSECTION Component Inspection
- CHECK STARTER CUT RELAY
- Turn ignition switch OFF.
- Disconnect starter cut relay.
- Check continuity between starter cut relay terminals.
Starter cut relay Condition Continuity Terminal 3 5 12 V direct current supply between terminals 1 and 2 Yes No current supply No Is the inspection result normal?
YES
Inspection End.
NO
Replace starter cut relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.