Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Confirmation Procedure
2015 Nissan-Datsun Rogue SV, AWDSECTION DTC Confirmation Procedure
- PERFORM DTC CONFIRMATION PROCEDURE
- Press push-button ignition switch under the following conditions to start engine:
- Selector lever: In the P position
- Brake pedal: Depressed
- Wait 1 second after engine started.
- Check DTC in "Self Diagnostic Result" of "BCM" using CONSULT.
Is DTC detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO
Inspection End.
- Press push-button ignition switch under the following conditions to start engine:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.