Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO, VISUAL & NAVIGATION SYSTEM (NAVIGATION WITH BOSE)DTC INDEX
2015 Nissan-Datsun Rogue SV, AWD
DTC Index
2015 Nissan-Datsun Rogue SV, AWDSECTION DTC Index
DTC INDEX
| DTC | Description |
|---|---|
| DTC U0428 | STEERING ANGLE SENSOR |
| DTC U1000 | CAN COMM CIRCUIT |
| DTC U1010 | CONTROL UNIT (CAN) |
| DTC U111A | REAR CAMERA IMAGE SIGNAL CIRCUIT |
| DTC U111B | SIDE CAMERA RH IMAGE SIGNAL CIRCUIT |
| DTC U111C | FRONT CAMERA IMAGE SIGNAL CIRCUIT |
| DTC U111D | SIDE CAMERA LH IMAGE SIGNAL CIRCUIT |
| DTC U1217 | AV CONTROL UNIT |
| DTC U1229 | AV CONTROL UNIT |
| DTC U122F | AV CONTROL UNIT |
| DTC U1232 | STEERING ANGLE SENSOR |
| DTC U1244 | GPS ANTENNA |
| DTC U1258 | SATELLITE RADIO ANTENNA |
| DTC U1263 | USB |
| DTC U1265 | BOSE AMP. |
| DTC U12AA | CONFIGURATION ERROR |
| DTC U12AB | ANTENNA |
| DTC U12AC | AV CONTROL UNIT |
| DTC U12AD | AV CONTROL UNIT |
| DTC U12AE | AV CONTROL UNIT |
| DTC U12AF | AV CONTROL UNIT |
| DTC U12B0 | POWER SUPPLY VOLTAGE |
| DTC U12B1 | POWER SUPPLY VOLTAGE |
| DTC U1300 | AV COMM CIRCUIT |
| DTC U1304 | CAMERA IMAGE CALIBRATION |
| DTC U1305 | CONFIG UNFINISH |
| DTC U1310 | CONTROL UNIT (AV) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.