Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXBRAKE CONTROL SYSTEM DTCS
2015 Nissan-Datsun Rogue SV, AWD
Brake Control System DTCS
2015 Nissan-Datsun Rogue SV, AWDSECTION Brake Control System DTCS
BRAKE CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description |
|---|---|
| DTC C1101, C1102, C1103, C1104 | WHEEL SENSOR |
| DTC C1105, C1106, C1107, C1108 | WHEEL SENSOR |
| DTC C1109 | POWER AND GROUND SYSTEM |
| DTC C1111 | PUMP MOTOR |
| DTC C1113, C1145, C1146 | YAW RATE/SIDE/DECEL G SENSOR |
| DTC C1115 | ABS SENSOR [ABNORMAL SIGNAL] |
| DTC C1120, C1122, C1124, C1126 | ABS IN VALVE SYSTEM |
| DTC C1121, C1123, C1125, C1127 | ABS OUT VALVE SYSTEM |
| DTC C1130 | ENGINE SIGNAL |
| DTC C1140 | ACTUATOR RELAY SYSTEM |
| DTC C1142 | PRESS SENSOR |
| DTC C1143 | STEERING ANGLE SENSOR |
| DTC C1144 | INCOMPLETE STEERING ANGLE SENSOR ADJUSTMENT |
| DTC C1155 | BRAKE FLUID LEVEL SWITCH |
| DTC C1160 | DECEL G SEN SET |
| DTC C1164, C1165 | CV SYSTEM |
| DTC C1170 | VARIANT CODING |
| DTC C1197 | VACUUM SENSOR |
| DTC C1198 | VACUUM SENSOR |
| DTC C1199 | BRAKE BOOSTER |
| DTC C119A | VACUUM SENSOR |
| DTC U1000 | CAN COMM CIRCUIT |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.