Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Confirmation Procedure
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Turn the ignition switch OFF to ON.CAUTION:
Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
- Perform "Self Diagnostic Result" of "CHASSIS CONTROL".
Is DTC "C1B99-00" detected?
YES
Proceed to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: Inspection End.
- Turn the ignition switch OFF to ON.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.