Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSDRIVER ASSISTANCE SYSTEM (DRIVER ASSISTANCE SYSTEM)BASIC INSPECTIONDISTANCE SENSOR INITIAL VERTICAL ALIGNMENTPREPARATION
2015 Nissan-Datsun Rogue SV, AWD
Distance Sensor Initial Vertical Alignment: Preparation
2015 Nissan-Datsun Rogue SV, AWDSECTION Preparation
- PREPARATION FOR DISTANCE SENSOR INITIAL VERTICAL ALIGNMENT PROCEDURE
- Verify correct vehicle suspension height. Refer to WHEEL .
- Repair or replace any damaged body components.
- Verify proper tire inflation pressures. Refer to TIRE AIR PRESSURE .
- Remove any accumulations of mud, snow or ice from the vehicle underbody.
- Verify that there is no load in the vehicle (cargo or passenger).
- Place the vehicle on a known level horizontal surface such as a wheel or frame alignment rack to achieve satisfactory sensor vertical alignment results.
- Remove front fascia. Refer to REMOVAL AND INSTALLATION .
Refer to DISTANCE SENSOR INITIAL VERTICAL ALIGNMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.