Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015MICRA SV, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (INTRODUCTION, WIRING DIAGRAMS AND BASIC INSPECTION)SYSTEM DESCRIPTIONCOMPONENT PARTSENGINE CONTROL SYSTEMCOMPONENT LOCATIONENGINE ROOM COMPARTMENT
2015 Nissan-Datsun Micra SV, Standard Trans
Engine Room Compartment
2015 Nissan-Datsun Micra SV, Standard TransSECTION Engine Room Compartment
| No. | Component | Function |
|---|---|---|
| 1. | ECM | ECM |
| 2. | IPDM E/R | IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from various sensors and the request signals received from control units via CAN communication. Refer to COMPONENT LOCATION for detailed installation location. |
| 3. | Mass air flow sensor | MASS AIR FLOW SENSOR |
| 4. | Electric throttle control actuator | ELECTRIC THROTTLE CONTROL ACTUATOR |
| 5. | EVAP canister purge volume control solenoid valve | EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE |
| 6. | Refrigerant pressure sensor | REFRIGERANT PRESSURE SENSOR Refer to COMPONENT LOCATION for detailed installation location. |
| 7. | Cooling fan motor | COOLING FAN |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.