Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Exploded View With Torque Specifications
2015 Nissan-Datsun Juke SL, 4WDSECTION Exploded View With Torque Specifications
WARNING: This page is about a different variant/trim than selected.
| 1. | Cylinder Block | 2. | Top Ring | 3. | Second Ring |
| 4. | Oil Ring | 5. | Piston | 6. | Piston Pin |
| 7. | Snap Ring | 8. | Connecting Rod | 9. | Connecting Rod Bearing (Upper) |
| 10. | Connecting Rod Bearing (Lower) | 11. | Crankshaft Key | 12. | Connecting Rod Cap |
| 13. | Connecting Rod Cap Bolt | 14. | Main Bearing Cap Bolt | 15. | Main Bearing Beam |
| 16. | Main Bearing Cap | 17. | Main Bearing (Lower) | 18. | Crankshaft |
| 19. | Pilot Converter (CVT Models) | 20. | Signal Plate | 21. | Rear Oil Seal |
| 22. | Drive Plate (CVT Models) | 23. | Reinforcement Plate (CVT Models) | 24. | Main Bearing (Upper) |
| 25. | Thrust Bearing | 26. | Oil Temperature Sensor | 27. | Oil Pressure Sensor |
| 28. | Knock Sensor | 29. | Flywheel (M/T Models) | 30. | Cylinder Block Heater (For Canada) |
| A. | Comply with assembly procedure when tightening. Refer to DISASSEMBLY AND ASSEMBLY | B. | Chamfered | ||
| Arrow | Crankshaft Side |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.