Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Exploded View With Torque Specifications
2015 Nissan-Datsun Juke SL, 4WDSECTION Exploded View With Torque Specifications
WARNING: This page is about a different variant/trim than selected.
| 1. | Exhaust Valve Timing Control Position Sensor | 2. | O-Ring | 3. | Camshaft Bracket |
| 4. | Camshaft (EXH) | 5. | Camshaft Sprocket (EXH) | 6. | Camshaft Sprocket (INT) |
| 7. | Camshaft (INT) | 8. | Valve Lifter (EXH) | 9. | Valve Lifter (INT) |
| 10. | Signal Plate (INT) | 11 | Signal Plate (EXH) | 12. | O-Ring |
| 13. | Camshaft Position Sensor (PHASE) | ||||
| A. | Comply with the assembly procedure when tightening. Refer to REMOVAL AND INSTALLATION |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.