SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (ENGINE CONTROL SYSTEM (NISMO RS - DTC TESTS P0190-P1451))DTC/CIRCUIT DIAGNOSISDTC P1078: EVT CONTROL POSITION SENSORDTC LOGICDTC DETECTION LOGIC
2015 Nissan-Datsun Juke SL, 4WD

DTC Detection Logic

2015 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
WARNING: This page is about a different variant/trim than selected.
DTC No. Trouble Diagnosis Name
(Trouble Diagnosis Content)		 DTC Detecting Condition Possible Cause
P1078 EXH TIM SEN/CIRC-B1
(Exhaust valve timing control position sensor circuit)		 An excessively high or low voltage from the sensor is sent to ECM.
  • Harness or connectors

    (Exhaust valve timing control position sensor circuit is open or shorted)

    (Camshaft position sensor circuit is open or shorted)

    (Fuel rail pressure sensor circuit is open or shorted.)

    (Battery current sensor circuit is open or shorted.)

    (G sensor circuit is open or shorted.)

    (Accelerator pedal position sensor 2 circuit is open or shorted.)

    (Turbocharger boost sensor circuit is open or shorted.)

    (Engine oil pressure sensor circuit is open or shorted.)

  • Accumulation of debris to the signal pick-up portion of the camshaft
  • Exhaust valve timing control position sensor
  • Crankshaft position sensor
  • Camshaft position sensor
  • Fuel rail pressure sensor
  • Battery current sensor
  • G sensor
  • Accelerator pedal position sensor 2
  • Turbocharger boost sensor
  • Engine oil pressure sensor
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.