Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Detection Logic
2015 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
WARNING: This page is about a different variant/trim than selected.
NOTE:
- If DTC P0500 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P0500 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to DTC LOGIC .
| DTC No. | Trouble Diagnosis Name (Trouble Diagnosis Content) |
DTC Detecting Condition | Possible Cause |
|---|---|---|---|
| P0500 | VEH SPEED SEN/CIRC (Vehicle speed sensor) |
The vehicle speed signal sent to ECM is almost 0 km/h (0 MPH) even when vehicle is being driven. |
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.