Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (ENGINE CONTROL SYSTEM (NISMO RS - DTC TESTS P0190-P1451))DTC/CIRCUIT DIAGNOSISDTC P0500: VSSM/T MODELSCOMPONENT FUNCTION CHECKDIAGNOSTIC TEST
2015 Nissan-Datsun Juke SL, 4WD
Diagnostic Test
2015 Nissan-Datsun Juke SL, 4WDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- PERFORM COMPONENT FUNCTION CHECK
With GST
- Lift up drive wheels.
- Start engine.
- Read vehicle speed signal in Service $01 with GST.
The vehicle speed signal on GST should be able to exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.
Is the inspection result normal?
YES
INSPECTION END
NO
Proceed to DIAGNOSIS PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.