SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 14 (MANUAL TRANSAXLE (6MT: RS6F52H))UNIT DISASSEMBLY AND ASSEMBLYINPUT SHAFT AND GEARSEXPLODED VIEW WITH TORQUE SPECIFICATIONS
2015 Nissan-Datsun Juke SL, 4WD

Exploded View With Torque Specifications

2015 Nissan-Datsun Juke SL, 4WDSECTION Exploded View With Torque Specifications
WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Input Shaft And Gears
G08179990Courtesy of NISSAN NORTH AMERICA, INC.
1. Input Shaft Front Bearing 2. Input Shaft 3. 3rd Needle Bearing
4. 3rd Input Gear 5. 3rd Inner Baulk Ring 6. 3rd Synchronizer Cone
7. 3rd Outer Baulk Ring 8. 3rd-4th Spread Spring 9. 3rd-4th Shifting Insert
10. 3rd-4th Synchronizer Hub 11. 4th Baulk Ring 12. 3rd-4th Coupling Sleeve
13. 4th Input Gear Bushing 14. 4th Needle Bearing 15. 4th Input Gear
16. Thrust Washer 17. 5th Input Gear Bushing 18. 5th Needle Bearing
19. 5th Input Gear 20. 5th Baulk Ring 21. 5th-6th Spread Spring
22. 5th-6th Shifting Insert 23. 5th-6th Synchronizer Hub 24. 5th-6th Coupling Sleeve
25. 6th Baulk Ring 26. 6th Input Gear 27. 6th Needle Bearing
28. 6th Input Gear Bushing 29. Snap Ring 30. Input Shaft Rear Bearing
31. Oil Channel 32. Input Shaft Rear Bearing Adjusting Shim 33. Retaining Pin
34. Reverse Idler Shaft 35. Thrust Needle Bearing 36. Reverse Idler Gear Needle Bearing
37. Reverse Insert Spring 38. Reverse Idler Gear (Front) 39. Reverse Baulk Ring
40. Reverse Coupling Sleeve 41. Reverse Idler Gear (Rear) 42. Reverse Idler Gear Adjusting Shim
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.