Engine Oil: Refilling

2015 Nissan-Datsun Juke SL, 4WDSECTION Refilling
WARNING: This page is about a different variant/trim than selected.
  1. Install drain plug with new drain plug washer. Refer to EXPLODED VIEW .
    CAUTION:

    Be sure to clean drain plug and install with new drain plug washer.

    Tightening torque : Refer to EXPLODED VIEW .
  2. Refill with new engine oil.

    Engine oil specification and viscosity: Refer to Β FLUIDS AND LUBRICANTSΒ  .Β 

    Engine oil capacity : Refer to PERIODICAL MAINTENANCE SPECIFICATIONΒ .
    CAUTION:
    • The refill capacity depends on the engine oil temperature and drain time. Use these specifications for reference only.
    • Always use oil level gauge to determine the proper amount of engine oil in the engine.
  3. Warm up engine and check area around drain plug and oil filter for engine oil leakage.
  4. Stop engine and wait for 10 minutes.
  5. Check the engine oil level. Refer to INSPECTIONΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.