Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (EXCEPT NISMO RS ECU DIAGNOSIS & DTC TESTS U0101-P0137)DTC/CIRCUIT DIAGNOSISDTC P0096: IAT SENSOR 2DTC LOGICDTC DETECTION LOGIC
2015 Nissan-Datsun Juke SL, 4WD
DTC Detection Logic
2015 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
| DTC No. | Trouble diagnosis name (Trouble diagnosis content) |
DTC detecting condition | Possible cause |
|---|---|---|---|
| P0096 | IAT SENSOR 2 B1 [Intake air temperature (IAT) sensor 2 circuit range/performance] |
The comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor 1, IAT sensor 2, ECT sensor, FTT sensor, and EOT sensor) shows that the voltage signal of the IAT sensor 2 is higher/lower than that of other temperature sensors when the engine is started with its cold state. |
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.