SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (EXCEPT NISMO RS DTC TESTS P2162-P26AB & CIRCUIT TESTS)DTC/CIRCUIT DIAGNOSISDTC P26A5: MULTI-WAY CONTROL VALVE POSITION SENSORDTC LOGICDTC DETECTION LOGIC
2015 Nissan-Datsun Juke SL, 4WD

DTC Detection Logic

2015 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
NOTE:
  • If DTC P26A5 is displayed with DTC P0117 or P0118, first perform the trouble diagnosis for DTC P0117 or P0118. Refer to DTC INDEX .
  • If DTC P26A5 is displayed with DTC P26A3 first perform the trouble diagnosis for DTC P26A3. Refer to DTC LOGIC .
  • If DTC P26A5 is displayed with DTC P26A6, or P26A7 first perform the trouble diagnosis for DTC P26A6, or P26A7. Refer to DTC LOGIC .
DTC No. Trouble Diagnosis Name
(Trouble Diagnosis Content)		 DTC Detecting Condition Possible Cause
P26A5 ENGINE COOLANT B/V A POSI SEN
(Engine coolant bypass valve A position sensor circuit range/performance)		 ECM detects the following status:
  • A voltage signal transmitted from the multi-way control valve position sensor is 4.76 V or more/4.3 V or less. Outside the above threshold when the valve is moved to the upper side stopper after ignition OFF.
  • A voltage signal transmitted from the multi-way control valve position sensor is 0.8 V or more/0.34 or less. Outside the threshold when the valve is moved to the lower side stopper after engine start.
  • Harness or connectors

    (Multi-way control valve position sensor circuit is open or shorted.)

  • Multi-way control valve position sensor
 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.