Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (EXCEPT NISMO RS DTC TESTS P046F-P2138)DTC/CIRCUIT DIAGNOSISDTC P062F: CONTROL MODULEDTC LOGICDTC CONFIRMATION PROCEDURE
2015 Nissan-Datsun Juke SL, 4WD
DTC Confirmation Procedure
2015 Nissan-Datsun Juke SL, 4WDSECTION DTC Confirmation Procedure
- PRECONDITIONING
If DTC Confirmation Procedure is previously conducted, always turn ignition switch OFF and wait at least 30 seconds before conducting the next test.
GO TO STEP 2 .
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON and wait at least 5 second.
- Check the DTC.
Is the DTC detected?
YES
INSPECTION END
NO
Proceed to DIAGNOSIS PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.