SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (EXCEPT NISMO RS DTC TESTS P046F-P2138)DTC/CIRCUIT DIAGNOSISDTC P052A, P052B: INTAKE VALVE TIMING CONTROLDTC LOGICDTC DETECTION LOGIC
2015 Nissan-Datsun Juke SL, 4WD

DTC Detection Logic

2015 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
NOTE:

If DTC P052A or P052B is displayed with DTC P0075, perform the trouble diagnosis for DTC P0075. Refer to  DTC LOGIC  . 

DTC No. Trouble diagnosis
(Trouble diagnosis content)		 Detecting condition Possible cause
P052A CAMSHAFT POSITION TIMING B1
(Cold start "A" camshaft position timing over-advanced bank 1)		 There is a gap between angle of target and phase-control angle degree when the engine is in a cold condition.
  • Crankshaft position sensor
  • Camshaft position sensor
  • Intake valve timing control solenoid valve
  • Intake valve timing intermediate lock control solenoid valve
  • Accumulation of debris to the signal pick-up portion of the camshaft
  • Timing chain installation
  • Foreign matter caught in the oil groove for intake valve timing control
P052B CAMSHAFT POSITION TIMING B1
(Cold start "A" camshaft position timing over-retarded bank 1)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.