SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (EXCEPT NISMO RS - DTC TESTS P0138-P046E)DTC/CIRCUIT DIAGNOSISDTC P0441: EVAP CONTROL SYSTEMCOMPONENT FUNCTION CHECKDIAGNOSTIC TEST
2015 Nissan-Datsun Juke SL, 4WD

Diagnostic Test

2015 Nissan-Datsun Juke SL, 4WDSECTION Diagnostic Test

  1. PERFORM COMPONENT FUNCTION CHECK

    Without CONSULT 

    1. Lift up drive wheels.
    2. Start engine (VDC switch OFF) and warm it up to normal operating temperature.
    3. Turn ignition switch OFF, wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Turn ignition switch OFF, wait at least 10 seconds.
    6. Start engine and wait at least 70 seconds.
    7. Set voltmeter probes to ECM harness connector terminals under the following conditions.
      ECM
      Connector + -
      Terminal
      E19 121 148
    8. Check EVAP control system pressure sensor value at idle speed and note it.
    9. Establish and maintain the following conditions for at least 1 minute.
      Air conditioner switch ON
      Head lamp switch ON
      Rear window defogger switch ON
      Engine speed Approx. 3, 000 RPM
      Gear position Any position other than P, N or R
    10. Verify that EVAP control system pressure sensor value stays 0.1 V less than the value at idle speed (measured at step 6) for at least 1 second.

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Proceed to DIAGNOSIS PROCEDURE .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.