SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (EXCEPT NISMO RS - DTC TESTS P0138-P046E)DTC/CIRCUIT DIAGNOSISDTC P0335: CKP SENSOR (POS)DTC LOGICDTC DETECTION LOGIC
2015 Nissan-Datsun Juke SL, 4WD

DTC Detection Logic

2015 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
NOTE:

If DTC P0340 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643.

Refer to DTC LOGIC .

DTC No. Trouble Diagnosis Name
(Trouble Diagnosis Content)		 DTC Detecting Condition Possible Cause
P0335 CKP SEN/CIRCUIT
[Crankshaft position sensor (POS) circuit]
  • The crankshaft position sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking.
  • The proper pulse signal from the crankshaft position sensor (POS) is not sent to ECM while the engine is running.
  • The crankshaft position sensor (POS) signal is not in the normal pattern during engine running.
  • Harness or connectors

    [Crankshaft position sensor (POS) circuit is open or shorted.]

  • Crankshaft position sensor (POS)
  • Signal plate
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.