SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (EXCEPT NISMO RS - DTC TESTS P0138-P046E)DTC/CIRCUIT DIAGNOSISDTC P0181: FTT SENSORCOMPONENT FUNCTION CHECKDIAGNOSTIC TEST
2015 Nissan-Datsun Juke SL, 4WD

Diagnostic Test

2015 Nissan-Datsun Juke SL, 4WDSECTION Diagnostic Test

  1. CHECK FUEL TANK TEMPERATURE (FTT) SENSOR

    1. Turn ignition switch OFF.
    2. Disconnect fuel level sensor unit and fuel pump harness connector.
    3. Remove fuel level sensor unit. Refer to REMOVAL AND INSTALLATION (2WD models), REMOVAL AND INSTALLATION (AWD models).
    4. Check resistance between fuel level sensor unit and fuel pump terminals by heating with hot water as shown in the figure below.
      Fig 1: Checking Fuel Tank Temperature Sensor
      G00498927Courtesy of NISSAN NORTH AMERICA, INC.
      Terminals Condition Resistance (kΩ)
      4 and 5 Temperature [°C (°F)] 20 (68) 2.3 - 2.7
      50 (122) 0.79 - 0.90

    Is the inspection result normal?

    YES 

    GO TO STEP 2  .

    NO 

    Proceed to DIAGNOSIS PROCEDURE .

  2. CHECK INTERMITTENT INCIDENT

    Check intermittent incident. Refer to INTERMITTENT INCIDENT .

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Proceed to DIAGNOSIS PROCEDURE .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.