SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE MECHANICALENGINE MECHANICAL (EXCEPT NISMO RS)UNIT DISASSEMBLY AND ASSEMBLYCYLINDER BLOCKEXPLODED VIEW WITH TORQUE SPECIFICATIONS
2015 Nissan-Datsun Juke SL, 4WD

Exploded View With Torque Specifications

2015 Nissan-Datsun Juke SL, 4WDSECTION Exploded View With Torque Specifications
Fig 1: Exploded View Of Cylinder Block With Torque Specifications
GNSJPBIA5036GB-036Courtesy of NISSAN NORTH AMERICA, INC.
1. Cylinder Block 2. Top Ring 3. Second Ring
4. Oil Ring 5. Piston 6. Piston Pin
7. Snap Ring 8. Connecting Rod 9. Connecting Rod Bearing (Upper)
10. Connecting Rod Bearing (Lower) 11. Crankshaft Key 12. Connecting Rod Cap
13. Connecting Rod Cap Bolt 14. Main Bearing Cap Bolt 15. Main Bearing Beam
16. Main Bearing Cap 17. Main Bearing (Lower) 18. Crankshaft
19. Signal Plate 20. Rear Oil Seal 21. Main Bearing (Upper)
22. Thrust Bearing 23. Oil Temperature Sensor 24. Oil Pressure Sensor
25. Knock Sensor        
A. Comply with the assembly procedure when tightening. Refer to DISASSEMBLY AND ASSEMBLY .        
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.