Calibrating Camera Image (Front Camera, Pass - Side Camera, Dr - Side Camera, And Rear Camera)

2015 Nissan-Datsun Juke SL, 4WDSECTION Calibrating Camera Image (Front Camera, Pass - Side Camera, Dr - Side Camera, And Rear Camera)

Perform the calibration of camera image caused by the incorrect mounting position of each camera, etc. Always perform calibration after performing the following work.

Fig 1: Camera Image Calibrating Screen Display
G08179289Courtesy of NISSAN NORTH AMERICA, INC.
  • When each camera or each camera mount (e.g. front grille, door mirror, and others) is removed
  • When replacing the around view monitor control unit

Refer to WORK PROCEDUREΒ  for the calibration procedure.

Adjustment Range Β 
Rotating Direction 31 patterns (16 on the center)
Upper/Lower Direction (- 22) - (+22)
Left/Right Direction (- 22) - (+22)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.