Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2WD Models
- REMOVE FUEL LEVEL SENSOR UNIT AND FUEL PUMP
Remove the fuel level sensor unit and fuel pump. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 2.Β
- CHECK FUEL LEVEL SENSOR UNIT AND FUEL PUMP
Check the resistance between fuel level sensor unit and fuel pump.
Courtesy of NISSAN NORTH AMERICA, INC.
Terminals Condition Resistance (Ξ©)
(Approx.)Height [mm (in)] Fuel level sensor unit and fuel pump 2 5 Full* (A) 51 142.8 (5.62) Empty* (B) 283 14.3 (0.563) * : When float rod is contact with stopper.
Is inspection result OK?
YESΒ
INSPECTION END
NOΒ
Replace fuel level sensor unit and fuel pump. Refer to REMOVAL AND INSTALLATION .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.