Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnosis Procedure
- REGISTER THE NEUTRAL POSITION OF THE STEERING ANGLE SENSOR
- Turn the ignition switch ON.
- Perform registration of the neutral position of the steering angle sensor. Refer to WORK PROCEDURE .
- Check "Self Diagnostic Result" of "AVM" with CONSULT.
Is "U1232" detected as the current malfunction?
YES
GO TO STEP 2.
NO
INSPECTION END
- CHECK STEERING ANGLE SENSOR
Check steering angle sensor. Refer to DTC INDEX .
Is the inspection result normal?
YES
Replace the around view monitor control unit. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace malfunctioning parts.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.