Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013MURANO CROSSCABRIOLETREPAIR AND DIAGNOSISGENERAL INFORMATIONIDENTIFICATIONGENERAL INFORMATION (CROSSCABRIOLET)BASIC INSPECTIONCONSULT/GST CHECKING SYSTEMCONSULT FUNCTION AND SYSTEM APPLICATION*1FUNCTION
2013 Nissan-Datsun Murano CrossCabriolet
CONSULT Function and System Application*1: Function
2013 Nissan-Datsun Murano CrossCabrioletSECTION Function
| Mode | Function | ||
|---|---|---|---|
| All DTC Reading | Display all DTCs or diagnostic items that all ECUs are recording and judging. | ||
| Work Support | This mode enables a technician to adjust some devices faster and more accurately. | ||
| Self Diagnostic Results | Retrieve DTC from ECU and display diagnostic items. | ||
| Data Monitor | Monitor the input/output signal of the control unit in real time. | ||
| CAN Diagnosis | This mode displays a network diagnosis result about CAN by diagram. | ||
| CAN Diagnosis Support Monitor | It monitors the status of CAN communication. | ||
| Active Test | Send the drive signal from CONSULT to the actuator. The operation check can be performed. | ||
| ECU Identification | Display the ECU identification number (part number etc.) of the selected system. | ||
| Configuration | Function to READ/WRITE vehicle configuration. | ||
| SRT&P-DTC Confirmation | The state of System Readiness Test (SRT) items, the presence or absence of permanent DTC(1), and driving conditions can be checked. | ||
| DTC work support | DTC reproduction procedure can be performed speedily and precisely. | ||
| Others | Other results or histories, etc. that are recorded in ECU are displayed. | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.