Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013MURANO CROSSCABRIOLETREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (INTRODUCTION) (CROSSCABRIOLET)BASIC INSPECTIONVIN REGISTRATIONWORK PROCEDURE
2013 Nissan-Datsun Murano CrossCabriolet
Work Procedure
2013 Nissan-Datsun Murano CrossCabrioletSECTION Work Procedure
- CHECK VIN
Check the VIN of the vehicle and note it. Refer to "INFORMATION ABOUT IDENTIFICATION OR MODEL CODE ".
: GO TO 2.
- PERFORM VIN REGISTRATION
With CONSULT
- Turn ignition switch ON with engine stopped.
- Select "VIN REGISTRATION" in "WORK SUPPORT" mode.
- Follow the instructions on the CONSULT display.
: END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.