Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2013MURANO CROSSCABRIOLETREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (DIAGNOSTIC CODES & SYMPTOM TESTS) (CROSSCABRIOLET)DTC/CIRCUIT DIAGNOSISVARIABLE INDUCTION AIR SYSTEMCOMPONENT FUNCTION CHECK

2013 Nissan-Datsun Murano CrossCabriolet

Component Function Check

2013 Nissan-Datsun Murano CrossCabrioletSECTION Component Function Check

CHECK OVERALL FUNCTION-I
With CONSULT
1. Start engine and warm it up to the normal operating temperature.
2. Perform "VIAS S/V-1" in "ACTIVE TEST" mode with CONSULT.
3. Turn VIAS control solenoid valve 1 "ON" and "OFF", and check that power valve actuator 1 rod moves.
  
  Fig 1: Checking Power Valve Actuator 1
  Courtesy of NISSAN NORTH AMERICA, INC.
Without CONSULT
1. Start engine and warm it up to the normal operating temperature.
2. Rev engine quickly up to approximately 5, 000 RPM.
3. Check that power valve actuator 1 rod moves.
  
  Fig 2: Checking Power Valve Actuator 1
  Courtesy of NISSAN NORTH AMERICA, INC.
  
  Is the inspection result normal?
  
  YES: GO TO 2.
  
  NO: "DIAGNOSIS PROCEDURE ".
CHECK OVERALL FUNCTION-II
With CONSULT
1. Perform "VIAS S/V-2" in "ACTIVE TEST" mode with CONSULT.
2. Turn VIAS control solenoid valve 2 "ON" and "OFF", and check that power valve actuator 2 rod moves.
  
  Fig 3: Checking Power Valve Actuator 2 (With Consult)
  Courtesy of NISSAN NORTH AMERICA, INC.
Without CONSULT
1. When revving engine up to 5, 000 RPM quickly.
2. Rev engine quickly up to approximately 5, 000 RPM.
3. Check that power valve actuator 2 rod moves.
  
  Fig 4: Checking Power Valve Actuator 2 (Without Consult)
  Courtesy of NISSAN NORTH AMERICA, INC.
  
  Is the inspection result normal?
  
  YES: INSPECTION END
  
  NO: "DIAGNOSIS PROCEDURE ".

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.