Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013MURANO CROSSCABRIOLETREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER CONTROL SYSTEM (IPDM/ER) (CROSSCABRIOLET)SYSTEM DESCRIPTIONSYSTEMRELAY CONTROL SYSTEMRELAY CONTROL SYSTEM: FAIL-SAFEIGNITION RELAY MALFUNCTION DETECTION FUNCTION
2013 Nissan-Datsun Murano CrossCabriolet
Ignition Relay Malfunction Detection Function
2013 Nissan-Datsun Murano CrossCabrioletSECTION Ignition Relay Malfunction Detection Function
- IPDM E/R monitors the voltage at the contact circuit and excitation coil circuit of the ignition relay inside it.
- IPDM E/R judges the ignition relay error if the voltage differs between the contact circuit and the excitation coil circuit.
- If the ignition relay cannot turn OFF due to contact seizure, it activates the tail lamp relay for 10 minutes to alert the user to the ignition relay malfunction when the ignition switch is turned OFF.
| Voltage judgment | IPDM E/R judgment | Operation | |
|---|---|---|---|
| Ignition relay contact side | Ignition relay excitation coil side | ||
| ON | ON | Ignition relay ON normal | - |
| OFF | OFF | Ignition relay OFF normal | - |
| ON | OFF | Ignition relay ON stuck |
|
| OFF | ON | Ignition relay OFF stuck | Detects DTC "B2099: IGN RELAY OFF" |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.