SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM - DTCS U0101 TO P0128DTC P0125: ECT SENSORDTC LOGICDTC DETECTION LOGIC
2013 Nissan-Datsun Juke SL, 4WD

DTC Detection Logic

2013 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
NOTE:
  • If DTC P0125 is displayed with P0116, first perform the trouble diagnosis for DTC P0116. Refer to "DTC LOGIC ".
  • If DTC P0125 is displayed with P0117 or P0118, first perform the trouble diagnosis for DTC P0117 or P0118. Refer to "DTC LOGIC ".
DTC No. Trouble diagnosis name (Trouble diagnosis content) DTC detecting condition Possible cause
P0125 ECT SENSOR (Insufficient engine coolant temperature for closed loop fuel control)
  • Voltage sent to ECM from the sensor is not practical, even when some time has passed after starting the engine.
  • Engine coolant temperature is insufficient for closed loop fuel control.
  • Harness or connectors (High resistance in the circuit)
  • Engine coolant temperature sensor
  • Thermostat
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.