Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM - DTCS U0101 TO P0128DTC P0096: IAT SENSOR 2COMPONENT FUNCTION CHECK
2013 Nissan-Datsun Juke SL, 4WD
Component Function Check
2013 Nissan-Datsun Juke SL, 4WDSECTION Component Function Check
- CHECK INTAKE AIR TEMPERATURE (IAT) SENSOR 2Β
- Turn ignition switch OFF.
- Disconnect turbocharger boost sensor harness connector.
- Check resistance between turbocharger boost sensor terminals as follows.
Turbocharger boost sensor Condition Resistance (kΞ©) + - Terminal 3 4 Temperature [Β°C (Β°F)] 25 (77) 1.80 - 2.20 Is the inspection result normal?Β
YES: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".
NO: Proceed to "DIAGNOSIS PROCEDUREΒ ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.