Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM - DTCS P1217 TO P2263DTC P1564: ASCD STEERING SWITCHCOMPONENT INSPECTION
2013 Nissan-Datsun Juke SL, 4WD
Component Inspection
2013 Nissan-Datsun Juke SL, 4WDSECTION Component Inspection
- CHECK ASCD STEERING SWITCH
- Disconnect combination switch (spiral cable) harness connector.
- Check the resistance between combination switch harness connector terminals as per the following conditions.
Combination switch (Spiral cable) Condition Resistance (Approx.) Connector + - Terminals M302 13 16 MAIN switch: Pressed 0 Ω CANCEL switch: Pressed 250 Ω COAST/SET switch: Pressed 660 Ω ACCEL/RES switch: Pressed 1, 480 Ω All ASCD steering switches: Released 4, 000 Ω Is the inspection result normal?
YES: INSPECTION END
NO: Replace ASCD steering switch. Refer to "EXPLODED VIEW ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.