Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEMDTC/CIRCUIT DIAGNOSISVDC OFF SWITCHCOMPONENT INSPECTION
2013 Nissan-Datsun Juke SL, 4WD
Component Inspection
2013 Nissan-Datsun Juke SL, 4WDSECTION Component Inspection
- CHECK VDC OFF SWITCH
- Turn the ignition switch OFF.
- Disconnect triple switch harness connector.
- Check the continuity between VDC OFF switch connector terminals.
VDC OFF switch Condition Continuity Terminal 1 - 2 When VDC OFF switch is pressed Existed When VDC OFF switch is not pressed Not existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace VDC OFF switch. Refer to "REMOVAL AND INSTALLATION ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.