Component Function Check

2013 Nissan-Datsun Juke SL, 4WDSECTION Component Function Check
  1. CHECK BRAKE WARNING LAMP FUNCTION (1)Β 

    Check that brake warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON.

    CAUTION: Never start engine.

    Is the inspection result normal?Β 

    YES: GO TO 2.

    NO: Proceed to "DIAGNOSIS PROCEDUREΒ ".

  2. CHECK BRAKE WARNING LAMP FUNCTION (2)Β 

    Check that brake warning lamp in combination meter turns ON/OFF when parking brake is operated.

    NOTE: Brake warning lamp turns ON when parking brake is operated (when parking brake switch is ON).

    Is the inspection result normal?Β 

    YES: GO TO 3.

    NO: Check the parking brake switch system. Refer to "DIAGNOSIS PROCEDUREΒ ".

  3. CHECK BRAKE WARNING LAMP FUNCTION (3)Β 

    Check that brake warning lamp in combination meter turns ON/OFF when brake fluid level switch is operated while brake fluid level in reservoir tank is with the specified level.

    NOTE: Brake warning lamp turns ON when brake fluid is less than the specified level (when brake fluid level switch is ON).

    Is the inspection result normal?Β 

    YES: INSPECTION END

    NO: Check the brake fluid level switch system. Refer to "DIAGNOSIS PROCEDUREΒ ".

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.