Adjustment Of Steering Angle Sensor Neutral Position: Description

2013 Nissan-Datsun Juke SL, 4WDSECTION Description

Always adjust the neutral position of steering angle sensor before driving when the following operation is performed.

x: Required -: Not required
Procedure Adjust the neutral position of steering angle sensor
Removing/installing ABS actuator and electric unit (control unit) -
Replacing ABS actuator and electric unit (control unit) x
Removing/installing steering angle sensor x
Replacing steering angle sensor x
Removing/installing steering components x
Replacing steering components x
Removing/installing suspension components x
Replacing suspension components x
Removing/installing tire -
Replacing tire -
Tire rotation -
Adjusting wheel alignment. x
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.