Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXTRANSFER CASE DTCS
2013 Nissan-Datsun Juke SL, 4WD
Transfer Case DTCS
2013 Nissan-Datsun Juke SL, 4WDSECTION Transfer Case DTCS
TRANSFER CASE DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| DTC P1804, P1809 | AWD CONTROL MODULE |
| DTC P1808 | WHEEL SPEED SENSOR |
| DTC P1811 | POWER SUPPLY CIRCUIT FOR AWD CONTROL MODULE |
| DTC P1813 | AWD MODE SWITCH |
| DTC P181B | INCOMPLETE SELFSHUT |
| DTC P181D | ENGINE TORQUE SIGNAL |
| DTC P181E | STEERING ANGLE SENSOR |
| DTC P181F | INCOMPLETE CALIBRATION |
| DTC P1820 | ENGINE SPEED SIGNAL |
| DTC P1829 | ACCELERATOR PEDAL POSITION SENSOR |
| DTC P182D | AWD SOLENOID (LEFT) |
| DTC P182E | AWD SOLENOID (RIGHT) |
| DTC P1830 | ABS OPERATION SIGNAL |
| DTC P1831 | VDC OPERATION SIGNAL |
| DTC P1832 | TCS OPERATION SIGNAL |
| DTC P183B | SOLENOID POWER SUPPLY |
| DTC P183C | DECEL G SENSOR |
| DTC P183D | SIDE G SENSOR |
| DTC P183E | YAW RATE SENSOR |
| DTC P183F | GEAR POSITION SIGNAL |
| DTC P1840 | OUTPUT SPEED SIGNAL |
| DTC P1864 | INPUT SPEED SIGNAL |
| DTC P1865 | GEAR RATIO SIGNAL |
| DTC U1000 | CAN COMM CIRCUIT |
| DTC U1010 | CONTROL UNIT (CAN) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.